Tannoy CMS 403DCE
SKU 0301-ABH
View on Tannoy siteOverview
CMS 3.0 CMS 403DCE
The CMS 403DCE is a full bandwidth 160-Watt high sensitivity loudspeaker that utilises our third generation Ceiling Monitor System technology (CMS 3.0). Thanks to an all-new proprietary 4" Dual Concentric point-source driver with Omnimagnet technology on a Torus Ogive Waveguide, the CMS 403DCE delivers wide and consistent broadband directivity with enhanced intelligibility – plus highly accurate and linear response.
Adjustable Tilt Angle
Specifically designed with a self-aligning 3 way clamp system for fast, simple and cost effective installation, the CMS 403DCE can be angled towards the listener within the fixed ceiling-mounting ring. By discreetly pivoting the loudspeaker towards the desired area of coverage, the challenge of speaker placement in a less than ideal room is easily overcome.
Optimised for Installation
Equipped with a low-insertion loss 30 W transformer with convenient front panel tap switching, CMS 403DCE features an integral ABS back-can with removable locking screw terminal connector and loop-thru functionality. The paintable powder coated steel mesh grille with dust protection, two tile support rails and one C-ring are all included. An optional plaster (mud) ring is available separately.
LAB GRUPPEN Ready
The CMS 403DCE is finished in semi matt white and optimised for use with LAB GRUPPEN LUCIA amplifiers, which accommodate up to 8 CMS Series loudspeakers per channel.8:
Specifications
Frequency response (-3 dB) <sup>(1)</sup>
- 110 Hz - 50 kHz BM Backcan
Frequency range (-10 dB) <sup>(1)</sup>
- 80 Hz - 54 kHz BM Backcan
System sensitivity (1 W @ 1 m) <sup>(2)</sup>
- 88 dB (1 W = 4 V for 16 Ohms)
Coverage angle (1 kHz to 6 kHz)
- —
Directivity factor (Q)
- —
Directivity index (DI)
- —
Dual concentric point source driver
- 1 x 100 mm (4.0") Dual Concentric driver, using Omnimagnet technology
Low frequency
- 35 mm (1.38") voice coil, treated multi fiber paper pulp cone
High frequency
- 20 mm (0.79") PEI dome
Safety features
- Safety ring located at rear of enclosure for load bearing safety bond
Clamping design
- Min / Max clamping range: 0.0 mm (0.0") /20.0 mm (0.79") Recommended clamp torque: 1.5 Nm
Included accessories
- C-Ring, tile-bridge kit, paint mask, cut-out template, grille
Optional accessories
- Plaster (mud) ring
Packed quantity
- 2
Talk to a consultant
Tell us about your venue, tour or install
Send a request and our engineers will come back with a system design, equipment list and budget — usually within one working day.